• Required reading for all forum users!!!

    Welcome!
    Register to access the full functionality of the GSResources forum. Until you register and activate your account you will not have full forum access, nor will you be able to post or reply to messages.

    A note to new registrants...
    All new forum registrations must be activated via email before you have full access to the forum.

    A Special Note about Email accounts!
    DO NOT SIGN UP USING hotmail, outlook, gmx, sbcglobal, att, bellsouth or email.com. They delete our forum signup emails.

    A note to old forum members...
    I receive numerous requests from people who can no longer log in because their accounts were deleted. As mentioned in the forum FAQ, user accounts are deleted if you haven't logged in for the past 6 months. If you can't log in, then create a new forum account. If you don't get an error message, then check your email account for an activation message. If you get a message stating that the email address is already in use, then your account still exists so follow the instructions in the forum FAQ for resetting your password.

    Have you forgotten your password or have a new email address? Then read the forum FAQ for details on how to reset it.

    Any email requests for "can't log in anymore" problems or "lost my password" problems will be deleted. Read the forum FAQ and follow the instructions there - that's what we have one for...

  • Returning Visitors

    If you are a returning visitor who never received your confirmation email, then odds are your email provider is blockinig emails from our server. The only thing that can be done to get around this is you will have to try creating another forum account using an email address from another domain.

    If you are a returning visitor to the forum and can't log in using your old forum name and password but used to be able to then chances are your account is deleted. Purges of the databases are done regularly. You will have to create a new forum account and you should be all set.

Lite Hone?

first timer

first timer

Forum Sage
I am in the process of rebuilding my 550 (leaky base gasket) any ways was just wondering if i could do a lite hone job on the cylinders and use the existing rings? one of the cylinder walls has a very light vertical scrach and i wanted to see if i could remove it. I looked at the piston/rings from that cylinder and the rings looked ok nothing chewed up or gauged.

On a side note any tips on how to polish piston crowns and combustion chamber? Not going to do any porting was hoping to polish to keep the carbon down. What kind of stuff do I need to get from Harbor Freight?
 
No value in polishing pistons or chambers - carbon will stick either way. Couldn't hurt to knock down any sharp edges but that's about it.

It's not advisable to hone if using old rings either. The parts are already mated to one another and honing will disturb the relationship between the parts.

Not sure how much new rings cost but I'd get them, along with a hone job, if they are not too much money.
 
Last edited:
I've used a flex-hone to lightly freshen bores a couple of times with excellent results. About 10 seconds per cylinder with a cordless drill does it. Keep the drill moving up and down for that lovely cross-hatch pattern.

However, I've always replaced the rings. Rings are only about $20 a set, so it's less trouble to scare up an extra $80 than to risk needing to re-do the whole thing.

I would only consider re-using rings if they were replaced very recently.
 
Check you end ring gap before and after.
You may need a bore job.
Just don't overdo it with the honing , or you will need a bore job
 
To test the ring gap take the rings off the piston. Put each ring in the cylinder it came out of and push it in straight with the piston. Measure the gap at the break in the ring. Check your manual for specs.
 
You must log in or register to reply here.
Back
Top