• Required reading for all forum users!!!

    Welcome!
    Register to access the full functionality of the GSResources forum. Until you register and activate your account you will not have full forum access, nor will you be able to post or reply to messages.

    A note to new registrants...
    All new forum registrations must be activated via email before you have full access to the forum.

    A Special Note about Email accounts!
    DO NOT SIGN UP USING hotmail, outlook, gmx, sbcglobal, att, bellsouth or email.com. They delete our forum signup emails.

    A note to old forum members...
    I receive numerous requests from people who can no longer log in because their accounts were deleted. As mentioned in the forum FAQ, user accounts are deleted if you haven't logged in for the past 6 months. If you can't log in, then create a new forum account. If you don't get an error message, then check your email account for an activation message. If you get a message stating that the email address is already in use, then your account still exists so follow the instructions in the forum FAQ for resetting your password.

    Have you forgotten your password or have a new email address? Then read the forum FAQ for details on how to reset it.

    Any email requests for "can't log in anymore" problems or "lost my password" problems will be deleted. Read the forum FAQ and follow the instructions there - that's what we have one for...

  • Returning Visitors

    If you are a returning visitor who never received your confirmation email, then odds are your email provider is blockinig emails from our server. The only thing that can be done to get around this is you will have to try creating another forum account using an email address from another domain.

    If you are a returning visitor to the forum and can't log in using your old forum name and password but used to be able to then chances are your account is deleted. Purges of the databases are done regularly. You will have to create a new forum account and you should be all set.

Need diameter of wheel hub (shaft drive)

  • Thread starter Thread starter johnnay
  • Start date Start date
J

johnnay

Guest
Hi all,

I need a measurement of the inner hub of a rear wheel for a GS shafty - the outside diameter of the bearing housing on the driven gear side. Anyone have one lying around that they could measure for me?? Thx!
 
bearing housing

bearing housing

have wheel & rear gear assembly but not just sure what measurement you are looking for but the bearinghousing oustside diameter in the wheel is 2.25in
where it goes inside the drive assembly also where the wheel goes inside the gear assembly is 8in ..
Let me know if you need more
 
If I understand you correctly, the measurement you're looking for is 58mm.

The bearing's OD is 47mm, and the outside diameter of the protrusion where it sits is 58mm (which actually converts to 2.28 in), measured with a set of digital calipers. Is this what you needed?
 
The 2.28 measurement was the one I was after...thanks for the responses!
 
I'm dying to know -- why did you need this measurement?

Just curious.
 
tinkering.... trying (perhaps in vain) to do a swap to a wider wheel. I'm currently looking at a wheel off a vmax and seeing if it can be modified to fit - to that end, I actually also need a measurement of the diameter of the six pins on the splined drive attachment - can you help me out?

If successful, I'll let everyone know... don't hold your breath, though - small child and hectic work means I don't get much time to work on it..:-D
 
You must log in or register to reply here.
Back
Top