New reg rec bought.. but whats what?

[bikerzx7r1981]

Hi as advised by the site I bought a new REG/REC from electrex-world its a RR10-a

The only problem is it has one red wire, an earth and 3 yellow wires so I'm a bit lost.

Does anyone know which should be fitted to what? i did try and join it up to the male female connectors.

I have tried a few combo's but not sure if it's right or not. I have it running approx 13.20 yet when I rev the engine it decreases to approx 12 but then goes back up to around 13.20... is this right please?

 

[bmac]

wiring an r/r

wiring an r/r

How could you be a bit lost. You took one off correct? Go to basscliff's tutorial and/or look up postplayer lots of great and well explained info. Bmac

 

[bikerzx7r1981]

bit lost as only had one yellow wire on the last one now have three, wasn't sure if I can just try them out in different combinations?

 

[Danjal]

Sounds like you had the original R/R and stator on there.

 

[bikerzx7r1981]

Yeah i think it was the original one, it had five wires, but just different colours.

Really not technical, ... i Know the red goes to red and earth is fine, just not sure about the other 3 wires.

Are the 3 remaining wires just stator wire, does it matter what order?

 

[bmac]

wiring

wiring

No, The 3 wires from the stator hook to the reg. no particular order, just very good connections. Follow the grounding procedure from Postplayr. Bob

 

[posplayr]

The same question came up very recently and I went to making a point to pint connection spreadsheet and so if you try and do it by colors alone it can be a bit confusing. See this post with the attached table.

After installing an aftermarket R/R you should have three open wires to tape back. The table shows that.

http://www.thegsresources.com/_forum/showpost.php?p=1237278&postcount=25

 

[rustybronco]

Kev, I have replied to your PM.

 

[srsupertrap]

Yeah i think it was the original one, it had five wires, but just different colours.

Really not technical, ... i Know the red goes to red and earth is fine, just not sure about the other 3 wires.

Are the 3 remaining wires just stator wire, does it matter what order?

The 3 wires go to the Stator & the order does not matter. If you had it hooked up like this and the battery voltage was 13.20 V at idle that 's OK per the Stator Paper. When you revved it up to 5000 rpm and the battery voltage drops you have voltage foldback due to excessive resistance in a electrical connection. Focus on the Fuse box & relay connections, they need to be real shinney.

Suggestion: List your GS Year/Model