A skunk in the works

[rustybronco]

Needs a new reservoir to go along with that new paint job...

[pete]

Needs a new reservoir to go along with that new paint job...

+1 Greg

And I like those pipes... very tasty

[SVSooke]

Well which one of you is going to buy me one then?Missing out on the Boulevard sale because there's no money in the kitty for that right now

[pete]

Well which one of you is going to buy me one then?Missing out on the Boulevard sale because there's no money in the kitty for that right now

Bugger! My budget is pre-spent also... could do with a brand new shifting setup from them but it won't get here in time either...

At least my budget is pre-spent on a safety certificate and rego

Or it could end up on clutch plates and springs if that doesn't work...

[rustybronco]

Well which one of you is going to buy me one then?Missing out on the Boulevard sale because there's no money in the kitty for that right now

There's no money in my kitty either... but that's not stopping me from ordering those boots.

[Hoosier Daddy]

Feeling the pinch on my disposable income here too! Damn holidays

Those Dunstall muffs and the factory pipes look like they were made for each other! Veeerrrryyy nice

[7981GS]

Needs a new reservoir to go along with that new paint job...

Thanks a lot for reminding me Rusty.
I bought 2 !
For LESS than I paid for a used M/C just for the reservoir.


Daniel

[SVSooke]

Without the Duny's


Not the best welds ever but they will do.Stainless wire in the MIG so they should last a while

[pete]

Without the Duny's


Not the best welds ever but they will do.Stainless wire in the MIG so they should last a while

About 1000% better than I can do Greg, well done

[SVSooke]

About 1000% better than I can do Greg, well done

Not me.A friend of mine at work did them.Not even thinking about how mine would look

[pete]

Not me.A friend of mine at work did them.Not even thinking about how mine would look

Cool, he does good work

I need a hell of a lot more practise before mine will even get close to neat...

[azr]

Friends are great! can't wait to hear her run.

[SVSooke]

You aren't the only one


Before and after on the pods

[SVSooke]

Did a bit of work yesterday.Stator side came off no problem.Looks like I don't need that gasket.Might get it anyway but.....
Looks like this inside

Also noticed this

Looks like the gear position indicator on my 750 without a cover.Is this how it should be?
Edit:started a new thread here http://www.thegsresources.com/_forum...d.php?t=186843

[SVSooke]

Stripped the paint off the engine and wire brushed then wet sanded the covers to be polished.Using Plasti-Kote 207 aluminium engine enamel.