Announcement

Collapse
No announcement yet.

1981 gs750 (gs750e) Retro Racer project

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    I bought a 6mm stanless steel rod, and made a pretty sturdy front bracket:





    It doesn't look like it in the pictures, but the front and back ends of the fender is the same with as the tyre. In the middle, it is a little bit narrower. I dont mind, as most of the water is thrown off the center of the tyre thread.

    I used the original HEL rubber protection to attach the brake line to the fender:



    Comment


      A couple of weeks ago I made a temporary licenseplate-holder to check out placement and angle. I was planning on using it this spring and make a better one later. It turned out to be way too flimsy, so I had to make another one.

      The flimsy one:



      The new one. It's not pretty, but if I like it I'll sandblast it and make it a bit nicer.







      Comment

      Working...
      X