Brake line union or none?

[cdnoel]

Got my hands on some braided steel brake line sets for my GS1100E. One set has two lines that banjo bolt directly to the master from the calipers. The other has one line from the master to a union fitting then two lines to the calipers. Just wondering wich set would work better?

 

[BassCliff]

Hi,

Lots of folks use the two-line setup because there are fewer connections to worry about. I don't think there is much difference in performance. Did you get a double length banjo bolt for the master cylinder?


Thank you for your indulgence,

BassCliff

 

[sk843143]

i would say that unions are ok ..... not perfered but ok .... just stay away from the compression fittings for brake lines

 

[koolaid_kid]

If they are correctly manufactured and installed, performance will be the same.
As Bass Cliff stated, the 2 line system is a bit simpler. I went with the 3 line system because I think it looks better and it retains the stock look.
Whatever floats your boat.

 

[Guest]

Got my hands on some braided steel brake line sets for my GS1100E. One set has two lines that banjo bolt directly to the master from the calipers. The other has one line from the master to a union fitting then two lines to the calipers. Just wondering wich set would work better?

I've used both and could not see any difference in performance ... only in the appearance.

 

[Guest]

I typically use a two line system, but put the double banjo on the left side caliper & run a short jumper (captured by the OEM brackets) to the right side caliper.

 

[GregT]

The two line from the mastercylinder style is easier to bleed so typically it's what is used on racebikes.

Greg T

 

[cdnoel]

Thanks.

Thanks.

Thanks.

I have the banjo bolts for both sets so I can go either way. I may try to see if one of my longer lines fits on the back brake so I can get rid of that rubber line as well. I don't use it much but the rubber lines do suck.

 

[Guest]

I vote no

 

[indyjoel]

Hi need some advice

I have been reading about having a single line to the caliper.

My AUS 650 has the setup in the pictures below at the front. I am not sure how best to change to stainless on these.

I think I will need seperate lines to each caliper and then seperate lines at each caliper side (left and right)

 

[koolaid_kid]

You are correct. The first picture is the union that some folk remove, and just run a line to each caliper from the master cylinder. This is the two line versus three line debate.
The second and third pictures show the anti-dive fork lines, which many people (myself included) no longer use. If you wish to retain this functionality, you will have to replace those lines as well.